Loading a truck camper for the first time may be tricky
You’ve outfitted your truck with Torklift TRUE Frame-Mounted Tie Downs and purchased FastGun truck camper turnbuckles. The anticipation of loading your truck camper onto the truck for its maiden voyage is getting you pumped up with excitement. You’ve even prepped your truck’s suspension with Torklift International StableLoads to help your vehicle stabilize the weight of the camper and eliminate any potential of handling issues.
If you’re a truck camper newbie your first experience might be similar to the following:
Back it up, Like a Mack truck
Once you’ve engaged the StableLoad suspension stabilizer into the gap of your truck’s leaf springs with the quick turn of a 3/8-inch ratchet, carefully remove and store the tailgate of your truck. Raise the camper jacks to the proper height above the truck bed to make way for loading. It’s important to load the camper so it’s positioned straight in the center of the truck bed. Line up the truck and watch for clearance on the wheel wells. It might be easier if you have a spotter to help you navigate while in reverse. If this is your first attempt at loading a camper, you’re probably on the verge of beast mode. We suggest going very slow and having patience. Make sure any power cords are clear of the camper so they don’t get cinched underneath it. Lower the jacks and camper into the truck bed and Touch Dowwwwn! Just like Seahawks’ Marshawn Lynch.
Popular board game
Connect Four
by Milton Bradley
How to install and adjust turnbuckles? Watch this video:
You may have noticed the “spring tension indicator” or O-ring on some of the camper turnbuckles. It’s popularly recognized on the number one selling truck camper turnbuckle worldwide, the Torklift International Original FastGun with quick-disconnect capability. Click here to see how to achieve the correct amount of tension needed and how the FastGun is literally the easiest “set and forget” turnbuckle installation. The FastGun turnbuckle allows you to connect four in less than four minutes…Voilà! The stars align.
Great things come in small form
Let’s take a closer look at the little black rubber band on the FastGun turnbuckle’s threaded rod. At this point you may be thinking, “Hold the phone – what is this dealy-bob?”
O-ring on Torklift turnbuckle
Truck camper manufacturers recommend 300 pounds of pressure be applied on all four points to properly hold a truck camper to a truck. The spring-loaded function is crucial because it allows some give while driving on rough and bumpy roads. The spring mechanism protects both your truck, tie down system and camper anchor points from any possibility of damage.
Seal of Approval
Since this O-ring is much like a seal for bolt configurations, many people overlook its true purpose. Since the coil spring is located inside the stainless steel body of the turnbuckle and not directly visible, we depend on the use the O-ring feature to tell us what’s going on in there.
With a FastGun turnbuckle, here’s how it works in 4 simple steps:
- Adjust turnbuckles into place
- Align the O-ring to the bottom of the turnbuckle body
- Snap down the quick-disconnect handle of the FastGun turnbuckle
- If the O-ring lowers by a quarter inch, you’ve achieved the correct amount of turnbuckle tension
If the O-ring or spring tension indicator is in the right position on your truck camper turnbuckle, consider it the “seal of approval” that you’ve successfully set up your truck and camper. Go forth and enjoy the adventures of the truck camping lifestyle.
Turnbuckle O-rings You’re good to go!
Click here to learn more about Torklift International Original FastGun turnbuckle.
Written by Sheryl Bushaw:
As a graduate from Arizona State University with a B.A. in Journalism and emphasis in Public Relations, Sheryl is a passionate writing professional with focus in areas of copy writing, social media and creative design. She is a travel enthusiast and explorer-extraordinaire with a zest for life.